Seaward 300 PrimeTest - Manual (Page 18)

PrimeTest 300 Operating Instructions
- 17 -
5.0 Getting Started
5.1 Charging New Batteries
Before using the PrimeTest 300 for the first time the
rechargeable cells provided will need to be inserted into
the unit and then charged. See section 16.4.
5.2 Power On
Switch on the PrimeTest 300 by pressing, and holding,
the green ON/START key. After 2-3 seconds the unit
will beep and the display will show a ‘boot up screen’.
This screen will show the firmware version installed.
The first time the PrimeTest 300 is powered up the User
will be automatically set to Admin. The Admin user
gives full access to all the menus and functionality of the
unit.
For further information about changing User and
Password see section 10.3 – Change User & section
10.4 – Change Password.
The PrimeTest 300 will now be ready to use in Manual
mode. Refer to section 11 for more details.
5.3 How to Navigate Menus
Most of the functions within the PrimeTest 300 can be
accessed from the menus.
Press Menu (F4) to select the main menu. Use the
up/down arrow keys to highlight the desired function or
sub-menu. Press either OK (F4) or the right arrow key to
select.
Note: An alternative method of navigating the menus
is to use the Fast Key option. Press Menu (F4)
and note that each menu option has a letter
underlined. By pressing that letter key the
menu option will be selected.
In many instances, the right arrow can also be
used to select a menu option.