Seaward 300 PrimeTest - Manual (Page 41)

PrimeTest 300 Operating Instructions
- 40 -
10.2.3 Auto Off Time (mins)
The PrimeTest 300 will power itself off after a period of
inactivity. This time is set here. Use the left/right arrow
keys to adjust the value between 1 minute and 10
minutes.
10.2.4 Data Entry
In Automatic mode it is required that an asset ID be
entered prior to starting a test sequence. Data entry can
be set to keypad only, keypad and barcode scanner or
keypad and RFID wand. Selecting Barcode Comments
will allow the keypad and barcode scanner to be used
for entering both the Asset ID and the Comments. Use
the left/right arrow keys to set.
Note: In data entry mode the unit will automatically
try to connect to a barcode scanner or RFID
wand via the internal Bluetooth module – if
neither is available this feature is simply
draining the batteries un-necessarily. In this
instance it is recommended that the unit be set
to Keypad only.
10.2.5 Backlight Mode
The backlight on the PrimeTest 300 can be set to either,
Always Off, Always On or come on in Power Save
mode. Power Save mode ensures that the backlight
comes on when a key is pressed and stays on for
several seconds before switching itself off again. Use
the left/right arrow keys to set.
10.2.6 Type of User
The user type can be set to Novice or Expert. For
Novice users, additional help prompts are provided
during test sequences.
10.2.7 Tones
The Tones (F3) key will open a screen which will allow
the various tones to be set up, i.e. Beep on Key Press or
Beep on Warning etc. Use up/down arrow keys to