Teo IPTelephone Network - Manual (Page 42)

Teo IP Telephone Network Administration Guide
Page 42 13-280132 Rev. Q
SIP Settings
XML Tag Data / Description
<sip_registration>
ON/OFF
</sip_registration>
Determines if registration with the SIP Registrar is
enabled.
If ON is selected, the phone will determine if an IP
address is available for the SIP Registrar; if so, it will
attempt to register with it.
If OFF is selected, registration is not attempted.
ON (default)
OFF
<sip_reg_exp>
seconds
</sip_reg_exp>
The number of seconds that the registration is valid
before the phone must re-register with the SIP Proxy.
Valid range is 10 to 7200 seconds (10 seconds to 2
hours) in the form xxxx with leading zeros
suppressed.
default value = 3600 (1 hour)
<sip_backup_proxy_addr>
address or name
</sip_backup_proxy_addr>
IP address or server name of the SIP Backup Server or
Redundant SIP Proxy.
address or name is the default address in IPv4 or
IPv6 format or DNS fully-qualified domain name.
If <sip_proxy_addr source= DHCP4> the address will be
provided by DHCP Option 120, if available.
<sip_backup_proxy_port>
port number
</sip_backup_proxy_port>
Port number used by the phone to send SIP signaling
messages, in the form xxxxx with leading zeros
suppressed.
1025 – 65534, default value = 5060
<sip_backup_reg_id>
address or name
</sip_backup_reg_id>
IP address or domain name of the SIP Registrar when
the Backup Proxy Server is used (most server
implementations combine this into a single SIP server
application).
If left blank or omitted, <sip_backup_proxy_addr> will
be used. This value is used inside SIP message
headers, in the form <line_id>@
<sip_backup_reg_id>:<sip_backup_reg_port>, to
reference the SIP server (e.g. [email protected]:5060
or 1000@teo:5060).