EXP Computer C4077-90960 - Manual (Page 122)

the left wall of the Stapling Bed. This cycle is repeated until the amount of
sheets to be stapled is reached (with a maximum of 20).
Stapling Cycle
The Sliders move the stack of sheets to the stapling position. The
Registration Pusher applies slight pressure to the stack of sheets toward
the left wall of the Stapling Bed, where the stapler is located. Then the
stack of sheets are stapled.
Eject Cycle
The stapling bed sliders offsets the stacks or jobs. The Off-Set Pusher
(located in the left side of the Top Cover Assembly) pushes the stack
towards the right side of the Stapling Bed, whenever it applies. The Sliders
move the stack of paper from stapling position to eject position, which is out
of the Stapling Bed (reaching the Wire Frame level). The Wire Frame
directs the stack of paper. The Exit Flap Assembly moves down to prevent
the job from returning to the Stapling Bed. The Sliders retract to home
position, letting the stack of sheets fall into the output bin. The capacity of
the output bin is 300 stapled sheets in jobs of five sheets or equivalent
combinations.
Power-On or Reset Sequence
At power-on or reset, events are performed in the following sequence:
1 Stapler Assembly is set to a ready state.
2 Retainer Assembly is turned to its initial position.
3 Rack Assembly is moved to find its home position, which is in the left side of
the Top Cover Assembly.
4 Slider Assembly is moved to find its home position, which is inside of the
Stapling Bed.
5 Slider Assembly is moved fully out from the Stapling Bed to the eject
position.
6 Rack Assembly is moved to activate the Exit Flap Assembly.
7 Slider Assembly is moved to its home position.
8 Rack Assembly is returned to its home position.
5
Functional Overview
Functional Overview 5-37