EXP Computer C4077-90960 - Manual (Page 133)

Required Tools
•
#2 magnetized Phillips screwdriver (6-inch shaft)
•
Small flat-blade Screwdriver
•
Small pair needle-nose pliers
•
T-15 Torx Driver ( 6-inch shaft)
All components in the printer and in the 2000-Sheet Input Unit use Phillips
head screws which require a #2 size Phillips screwdriver. Figure 6-1 shows
the difference between a Phillips and a Pozidriv screwdriver. Note that the
Phillips tip has more beveled surfaces.
All screws used in the field-replaceable Multi-Bin Mailbox/Mailbox With
Stapler components require a T-15 Torx driver.
Phillips vs. Posidriv Screwdrivers
N o t e See Table 6-1 and Chapter 8 for a table listing screws and other common
hardware used in the printer.
C a u t i o n To install a self-tapping screw, first turn it counter-clockwise to align it with
the existing thread pattern, then carefully turn clockwise to tighten. Do not
over-tighten. If a self-tapping screw-hold becomes stripped, repair of the
screw-hole or replacement of the affected assembly is required.
Figure 6-1
6-6 Removal and Replacement