EXP Computer C4077-90960 - Manual (Page 256)

Communication
Ask the customer to run a print job from the host system. If the print job is
successful, proceed to the following step, “Verification.”
Verify Communication
Print the PCL configuration page and study the HP MIO block. The MIO
block will appear on the bottom portion of the configuration page. An
example of a properly operating MIO block appears in Figure 7-9.
MIO Block on Configuration Page
•
If the MIO Jet Direct Card has successfully powered up and completed its
internal diagnostics, the "I/O CARD READY" message will appear. If
communication is lost, an "I/O NOT READY" message appears followed by a
two digit error code. Consult the HP JetDirect Network Interface
Configuration Guide for further details and recommended action.
•
The "Network Statistics" column indicate that the network activity has been
occurring. Bad packets, framing errors, un-sendable packets and collisions
should be minimal. If a high percentage (greater than one percent) of these
occur, contact the network administrator. All of the statistics are set to zero
when the printer is powered-off.
Node Name
IP Address
Network
Statistics
I/OCard
Ready
Figure 7-9
7
Troubleshooting
Troubleshooting 7-19