EXP Computer C4077-90960 - Manual (Page 68)

Setting Page Count, Maintenance Count,
and Serial Number
The page count, maintenance count, and printer serial numbers are stored
in Non-Volatile Memory. PAGECOUNT is the total number of images printed
by the printer, MAINTCOUNT is the pagecount when the next preventive
maintenance should be performed (every 350,000 images), and S.N. is the
printer serial number (also located on the printer back cover).
N o t e LaserJet 5Si HM (C3124A) has a 250,000 images user preventive
maintenance interval due to heavy media usage.
If it is necessary to replace the Formatter PCA, these numbers should be set
to the current values to accurately reflect the age of the print engine. The
procedures for setting these values are listed in Table 3-15.
Before removing the old Formatter PCA, print a PCL or PostScript
Configuration Page to verify the current values, if possible.
N o t e If it is not possible to print a PCL Configuration Page, try to verify the
values before replacing the Formatter PCA by following steps 1 through 3,
below.
After verifying the page count, maintenance count, and printer serial
number from the old Formatter PCA, replace it with the new PCA.
1 Enter the Service Mode as previously described in this chapter.
2 When SERVICE MODE is displayed, press [Menus] to access the Service Menu.
3 Press [Items to display PAGECOUNT=, MAINTCOUNT=, and S.N.=.
4 Enter the appropriate values for each item.
5 Press [On Line] to exit Service Mode.
3
Operating Overview
Operating Overview 3-23