EXP Computer C4077-90960 - Manual (Page 155)

Door Assembly, Diverter
1 Open the Diverter access door and release the support struts (Figure 6-13,
callout 1) by sliding the strut ends forward and downward.
2 Rotate the door up to align the flat sides of the right hinge pin with the
retaining slot (Figure 6-13, callout 2), and lift upwards to release it from the
retaining slot.
3 Continue lifting up on the right side of the door while pushing it to the left
to rotate the left hinge pin out of its locating cavity.
To Reinstall:
1 Insert the left side of the door into position first, and then rotate the right
side down to snap the hinge pins into position.
2 Reconnect the support struts to the chassis.
Diverter Door Assembly
Figure 6-13
6-28 Removal and Replacement