EXP Computer C4077-90960 - Manual (Page 25)

Adhesive Labels
Use the following guidelines when selecting labels:
C a u t i o n Tray 1 is required for printing adhesive labels.
Print labels to the Face-Up Bin only.
This printer does not support use of labels with any exposed spaces.
Do not attempt to print on label sheets after any of the labels have been
removed from the sheet. Damage to the printer may result.
•
Labels must be arranged on the carrier sheet so that there are no exposed
spaces on the sheet. Using label stock with spaces between rows or columns
of labels can often result in labels peeling off during printing, causing
serious jamming and possible printer damage.
•
The top sheet (printing surface) must be of copier quality and provide good
toner adhesion.
•
The carrier sheet (backing sheet) must be compatible with the temperatures
and pressure of the fusing process, and must be coated for easy release of
the top sheet.
•
The adhesive must be stable at the 392° F (200° C) temperatures
encountered for 0.1 second in the fusing process, and must not produce
emissions that exceed exposure levels or threshold limits established by
OSHA and other safety agencies. Adhesives must not come into direct
contact with any part of the printer.
A wide selection of suitable labels may be ordered through
Hewlett-Packard. Available sizes are listed in the HP LaserJet Printer
Family Paper Specification Guide.
Transparencies
C a u t i o n Tray 1 (Multi Purpose) is required for printing transparencies.
Print transparencies to the Face-Up Bin only.
Overhead transparencies used in HP LaserJet printers must be able to
withstand the 392° F (200° C) temperatures encountered in the printer’s
fusing process for 0.1 second. Suitable transparency film is available
through Hewlett-Packard. Refer to the HP LaserJet Printer Family Paper
Specification Guide for details.
1-12 Product Information