EXP Computer C4077-90960 - Manual (Page 182)

Registration Assembly
1 Open the top cover door and remove the toner cartridge.
2 Remove the Transfer Roller Assembly (see Figure 6-51).
3 Remove the Main Gear Train Shield. Release the retainer clip (Figure 6-43,
callout 1) and lift the forward end up.
4 Unplug the clutch cable from the clutch on the right end of the Registration
Assembly (Figure 6-42, callout 2).
5 Remove (2) screws, CH102, at rear of assembly (Figure 6-43, callout 3).
6 Lift the registration guide and remove (2) screws, CH102, at front of
assembly (Figure 6-44, callout 4).
To Reinstall:
1 Lift the registration guide and place the Registration Assembly into
position.
2 Lift the registration guide and make sure that the locator pin near the right
screw is properly positioned.
3 Make sure that the grounding strap is under the left screw.
4 Be sure to connect the clutch cable connector.
5 After replacing the (4) screws, replace the Main Gear Train Shield. Tilt the
top outward, tuck the lower tabs in place, and snap the cover down into
position.
N o t e The LaserJet 5Si HM (C3124A) requires a unique Registration Assembly.
6
Removal and Replacement
Removal and Replacement 6-55