AEC VacTrac Series Conveying Systems - Manual (Page 36)

VacTrac™ Conveying Systems 12-Station Controllers Page 35
WRITING PARAMETERS
TO FLASH-PLEASE WAIT
SAVING BACKUP
TO FLASH-PLEASE WAIT
The following screens display while the controller writes to flash
memory. Again, do not cycle power while these two screens
display.
Note: The controller needs about 30 seconds for saving to flash
memory. If the controller doesn’t clear this display within
60 seconds, you may need to cycle power. This rare type of
problem is caused by a write failure not detected by the
controller. This rare condition usually requires a complete
factory default reset for full recovery.