H3C Technologies H3C S7500E Series Switches - Manual (Page 147)

10-14
To do… Use the command… Remarks
Enter system view system-view —
Enable the trap function for
VRRP
snmp-agent trap enable vrrp
[ authfailure | newmaster ]
Optional
Enabled by default.
For more information about the snmp-agent trap enable vrrp command, see command
snmp-agent trap enable in SNMP Configutaion Commands in the Network Management and
Monitoring Command Reference.
Displaying and Maintaining VRRP for IPv4
To do… Use the command… Remarks
Display VRRP group status
display vrrp [ verbose ] [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
Available in any view
Display VRRP group statistics
display vrrp statistics [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
Available in any view
Clear VRRP group statistics
reset vrrp statistics [ interface
interface-type interface-number [ vrid
virtual-router-id ] ]
Available in user view
Configuring VRRP for IPv6
VRRP for IPv6 Configuration Task List
Complete these tasks to configure VRRP for IPv6:
Task Remarks
Specifying the Type of MAC Addresses Mapped to Virtual IPv6
Addresses
Optional
Creating a VRRP Group and Configuring a Virtual IPv6 Address Required
Configuring Router Priority, Preemptive Mode and Tracking Optional
Configuring VRRP Packet Attributes Optional