H3C Technologies H3C S7500E Series Switches - Manual (Page 87)

7-16
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
Follow these steps to specify a transit node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Specify the current device as a
transit node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specifying an edge node
When configuring an edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an edge node.
Follow these steps to specify an edge node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —
Specify the current device as a
transit node of the primary ring,
and specify the primary port and
the secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specify the current device as
the edge node of a subring, and
specify the edge port
ring ring-id node-mode edge [ edge-port
interface-type interface-number ]
Required
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before
configuring the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
Follow these steps to specify an assistant-edge node:
To do… Use the command… Remarks
Enter system view system-view —
Enter RRPP domain view rrpp domain domain-id —