H3C Technologies H3C S7500E Series Switches - Manual (Page 83)

7-12
Task Remarks
Configuring RRPP Timers
Optional
Perform this task on the master node in the RRPP
domain.
Enabling Fast Detection
Optional
Perform this task on the master node, edge node, and
assistant-edge node in the RRPP domain.
Configuring
RRPP Fast
Detection
Configuring Fast
Detection Timers
Optional
Perform this task on the master node in the RRPP
domain.
Configuring an RRPP Ring Group
Optional
Perform this task on the edge node and assistant-edge
node in the RRPP domain.
z RRPP does not have an auto election mechanism, so you must configure each node in the
ring network properly for RRPP to monitor and protect the ring network.
z Before configuring RRPP, you need to construct a ring-shaped Ethernet topology
physically.
Creating an RRPP Domain
When creating an RRPP domain, specify a domain ID, which uniquely identifies an RRPP
domain. All devices in the same RRPP domain must be configured with the same domain ID.
Make this configuration on devices you want to configure as nodes in the RRPP domain.
Follow these steps to create an RRPP domain:
To do… Use the command… Remarks
Enter system view system-view —
Create an RRPP domain and
enter RRPP domain view
rrpp domain domain-id Required
Configuring Control VLANs
Before configuring RRPP rings in an RRPP domain, configure the same control VLANs for all
nodes in the RRPP domain first.