Configuring nesting, Configuration procedure – H3C Technologies H3C S6300 Series Switches User Manual
Page 77
67
Configuring nesting
Nesting adds a VLAN tag to the matching packets to allow the VLAN-tagged packets to pass through the
corresponding VLAN. For example, you can add an outer VLAN tag to packets from a customer network
to a service provider network. This allows the packets to pass through the service provider network by
carrying a VLAN tag assigned by the service provider.
Configuration procedure
To configure nesting:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a traffic class and
enter traffic class view.
traffic classifier classifier-name [ operator { and
| or } ]
By default, no traffic class
exists.
3.
Configure match criteria.
if-match match-criteria
By default, no match
criterion is configured for
a traffic class.
For more information
about the match criteria,
see the if-match
command in ACL and
QoS Command
Reference.
4.
Return to system view.
quit
N/A
5.
Create a traffic behavior
and enter traffic behavior
view.
traffic behavior behavior-name
By default, no traffic
behavior exists.
6.
Configure a VLAN tag
adding action.
nest top-most vlan vlan-id
By default, no VLAN tag
adding action is
configured for a traffic
behavior.
7.
Return to system view.
quit
N/A
8.
Create a QoS policy and
enter QoS policy view.
qos policy policy-name
By default, no QoS policy
exists.
9.
Associate the traffic class
with the traffic behavior in
the QoS policy.
classifier classifier-name behavior
behavior-name
By default, no
class-behavior
association is configured
for a QoS policy.
10.
Return to system view.
quit
N/A