H3C Technologies H3C SecPath F1000-E - Manual (Page 58)

50
Hardware management and maintenance
This chapter describes how to display hardware information for the firewall, verify and diagnose
transceiver modules, troubleshoot system exceptions, and reboot the firewall.
NOTE:
The output depends on your software version.
Displaying hardware information
Displaying software and hardware version information
Use the display version command to display software and hardware version information for the firewall.
<Sysname> display version
H3C Comware Platform Software
Comware Software, Version 5.20, Release 3177
Copyright (c) 2004-2013 Hangzhou H3C Tech. Co., Ltd. All rights reserved.
H3C SecPath F1000-E uptime is 0 week, 0 day, 0 hour, 17 minutes
CPU type: XXX
1024M bytes DDR2 SDRAM Memory
4M bytes Flash Memory
495M bytes CF0 Card
PCB Version:Ver.B
Logic Version: 1.0
Basic BootWare Version: 2.01
Extend BootWare Version: 2.01
[FIXED PORT] CON (Hardware)Ver.B, (Driver)1.0, (Cpld)2.0
[FIXED PORT] AUX (Hardware)Ver.B, (Driver)1.0, (Cpld)2.0
[FIXED PORT] GE0/0 (Hardware)Ver.B, (Driver)1.0, (Cpld)2.0
[FIXED PORT] GE0/1 (Hardware)Ver.B, (Driver)1.0, (Cpld)2.0
[FIXED PORT] GE0/2 (Hardware)Ver.B, (Driver)1.0, (Cpld)2.0
[FIXED PORT] GE0/3 (Hardware)Ver.B, (Driver)1.0, (Cpld)2.0
[SUBSLOT 1] The SubCard is not present
[SUBSLOT 2] The SubCard is not present
Displaying running status data
For diagnosis or troubleshooting, you can use the display diagnostic-information command in any view
to bulk collect running data for multiple modules, rather than using separate display commands (such
as display clock, display version, display device, and display current-configuration) to collect running
status data module by module.
• Save running status data for multiple feature modules.