H3C Technologies H3C SecPath U200-A U200-M U200-S - Manual (Page 29)

20
To connect a fiber port to a peer device through optical fibers:
1. Remove the dust plug from the SFP port.
2. Remove the dust cover from the transceiver module, and plug the end without a pull latch into the
SFP port.
3. Remove the dust cover from the fiber connector.
4. Identify the Rx and Tx ports. Plug the LC connector at one end of one fiber cable into the Rx port
of the UTM device and the LC connector at the other end into the Tx port of the peer device. Plug
the LC connector at one end of another fiber cable into the Tx port of the UTM device and the LC
connector at the other end to the Rx port of the peer device.
Figure 22 Connecting the fiber port
5. View the LINK LED after connection:
{
On means a link is present.
{
Off means no line is present. Try to change the Rx and Tx ends of the fiber. For more
information about the LEDs, see "
UTM device panel LEDs ."
Connecting a power cord
1. Make sure the UTM device is properly grounded. For the U200-A and U200-M, make sure the
power is OFF.
2. Connect one end of the power cord to the receptacle on the UTM device, and the other end to the
AC power source.