Configuring ip addresses for interfaces – H3C Technologies H3C SecPath U200-A U200-M U200-S User Manual
Page 45
36
Item Description
HTTPS
Specify whether to enable the HTTPS service on the UTM device.
To enable the HTTPS service on the UTM device, select the Enable option and select
the HTTPS service port number.
By default, the HTTP service is disabled.
To improve the security of your connection to the UTM device, use HTTPS, which is
based on SSL.
IMPORTANT:
•
If you are using the HTTPS service, disabling the HTTPS service or changing the
service port number breaks your connection to the UTM device.
•
Make sure no other services are using the specified service port number.
•
HTTPS uses the PKI domain default by default. If the PKI domain does not exist,
you will see an error message at the end of the wizard. However, the other
configurations are not affected.
Configuring IP addresses for interfaces
1.
Click Next on the service management page to enter the interface IP address configuration page.
The list shows the IP address configuration information for all Layer 3 Ethernet interfaces and
VLAN interfaces.
Figure 38 Basic configuration wizard—4/6 (interface IP address configuration)
2.
Click the link for an interface to perform IP address configuration as described in
.