Logging in to the cli by using telnet – H3C Technologies H3C SecPath U200-A U200-M U200-S User Manual
Page 39
30
Memory Size : 512MB
Memory Speed : 533MHz
BootWare Size : 512KB
Flash Size : 32MB
cfa0 Size : 224MB
CPLD Version : 2.0
PCB Version : Ver.B
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Starting to get the main application file--cfa0:/u200s.bin!.................
............................................................................
............................................................................
............................................................................
..................................
The main application file is self-decompressing.............................
............................................................................
..........................................................................
Done!
System application is starting...
Press Ctrl+F to load firewall system...
##### start UTM mode #####
User interface con0 is available.
Press ENTER to get started.
After pressing Enter, you are placed in user view:
<H3C>
Now, you can configure and manage the UTM device.
Logging in to the CLI by using Telnet
This section provides only a simplified procedure for logging in to the CLI by using Telnet. For more
information, see the UTM device configuration guides.
The UTM device does not support Telnet login by default, but is provided with the following default
Telnet login information:
•
Username—admin.
•
Password—admin.
•
IP address for interface GigabitEthernet 0/0—192.168.0.1/24.
To log in to the CLI by using Telnet:
1.
Log in to the UTM device through the console port, execute the telnet server enable command in
system view to enable the Telnet service.