Grass Valley 2000NET v4.0.0 - Manual (Page 19)

2000NET Instruction Manual 19
Power Up
The module LEDs and their possible status and indicated conditions are
shown in
Table 2 .
Table 2. Indicator LEDs and Conditions Indicated
LED LED State Condition
POWER OK
(green)
Off Power is off or on-board regulator has failed
On continuously Module is powered
ETHER(NET)
(yellow)
Active Indicates communication taking place on the Ethernet bus
LNK
(green)
Active Indicates active link established with another device on the Ethernet bus
PS1
(red)
Off Power supply 1 is operating normally or is not installed
On continuously Power supply 1 is present and reporting output not within specified voltage range
PS2
(red)
Off Power supply 2 is operating normally or is not installed
On continuously Power supply 2 is present and reporting output not within specified voltage range
PS3
(red)
Off Power supply 3 is operating normally or is not installed
On continuously Power supply 3 is present and reporting output not within specified voltage range
PS4
(red)
Off Power supply 4 is operating normally or is not installed
On continuously Power supply 4 is present and reporting output not within specified voltage range
TEMP
(red)
Off 2000NET sensors reading temperature within specified parameters
On continuously Over-temperature condition detected in frame
FP (Front Panel)
(red)
Off
Currently not used
On
REM OVR
(yellow)
Off Module settings match those set onboard by switches and jumpers
On
One or more settings have been overridden by remote control system (see Table 3
on page 22 )
COMM
(yellow)
Active Indicates module is polling the devices on the internal frame communication bus
FAN
(red)
Off All fans in the frame are working properly
On continuously At least one fan in the frame is not rotating at its specified rate
FB (Frame Bus)
(red)
Off Network module is communicating with modules on the Frame Bus
On Internal Frame Bus communication failure
MOD
(red) Off None of the media or center communication/sync modules is reporting a fault
On continuously At least one of the media or center communication/sync modules is reporting a fault
NM
(Net Module)
(red)
Off Network Module is working properly
On continuously Network Module has detected an internal fault and is not functioning
FRAME STATUS
(Bi-Color
Red/Green)
Green
On continuously
Frame Status OK
Green
Flashing
Frame Locate indicator has been selected on the Frame Configuration web page
Red
Flashing
Fault or warning on the frame bus