J, k, l keyboard shortcuts for transport control, Using mouse wheel for transport control, Using mark-in and mark-out points – Grass Valley GV STRATUS v.3.1 User Manual
Page 169
2. In the Navigator panel, select the bin containing the asset to previewed.
The asset appears in the Asset List.
3. Drag the asset to the Source Viewer.
4. To navigate through the asset or to add or modify keywords, markers, or mark in and mark out
points, use the appropriate transport controls or keyboard shortcuts.
J, K, L keyboard shortcuts for transport control
The three keycaps J, K, and L on a standard keyboard can be used as transport control hotkeys in
Source Viewer. These three keys can be used to play video and audio forward, in reverse, and vary
speed as described below.
1. Load a video asset (clip) into an Inspector, Source Viewer, or Storyboard Editor tool.
2. Press the
J
key to start playing the clip in reverse.
3. Each time you press
J
, the reverse speed increases by 1X, 1.5X, 2X, 5X, 8X.
4. Hold down both the
J
and
K
keys.
This increases the speed of the video play in reverse by 1/10.
5. Press and hold down the
K
key while pressing
J
.
Now each press of
J
moves the video in reverse by one frame.
6. Press the
K
key to pause the video.
7. Press the
L
key to start playing the video forward.
8. Each time you press
L
, the forward speed increases by 1X, 1.5X, 2X, 5X, 8X.
9. Hold down both the
L
and
K
keys.
This increases the speed of the video forward play by 1/10.
10. Press and hold down the
K
key while pressing
L
Now each press of
L
moves the video forward by one frame.
Using mouse wheel for transport control
A PC mouse wheel can be used as a transport control to advance the position of media so that jogging
can be quick and efficient.
1. Select the asset in any window with transport controls using the mouse pointer.
2. Use the mouse wheel to move the media in both forward and reverse directions at the speed
desired.
Using mark-in and mark-out points
1. Navigate to the desired starting point using the scrub bar, and click the
Mark In
button.
(
I
)
2. Navigate to the desired end-point using the scrub bar, and click the
Mark Out
button.
(
O
)
Where timecode is displayed you can also right-click the timecode type label and select
Clear
Marks
to clear all current in/out marks.
2014 02 21
GV STRATUS User Manual
169
Editing