Grass Valley XtenDD v.4.2.4 - Manual (Page 475)

5. Application Notes
5 – 2 Operating Instructions – Rev. 1 / 7.2002
With Simulcast two new settings have been added: SimulcastMode and Simulcast-
Address.
D
Simulcast Mode
This value may have four states:
Default, MasterOnly, SlaveOnly and Both (with Default = MasterOnly).
After switching ON the control panel, it always has the state MasterOnly. It is
stored neither in the operational state nor in the applicational one.
D
SimulcastAddress
it contains the least significant byte of the Slave IP address. The address ’0’ is
considered to be undefined. Admissible are the addresses 1...254. It is an Envi-
ronment settings of the CP.
Both values can be modified via the control panel Setup menu settings (TiM/E
memo panel). Modifications are immediately effective.
The functions S–M (Simulcast Master only) and S–S (Simulcast Slave only) can
be assigned to the UPK capable buttons. As long as the corresponding button is
held down, transmission is only made to the selected device.
Control possibility of the assignment of an input substitution table (see sidepanel
menu Install / Ebox / Global). Entry possibilities for SimulcastAddress (see menu
Install/Panel).