JBL Synthesis SDP-45 4K - Manual (Page 20)

Basic Operation
JBL SYNTHESIS SDP-45
- 20 -
1 HDMI Inputs
HDMI inputs 1 through 8 are hardwired to Source inputs 1 through 8 as
listed on the front panel from left to right. HDMI video is routed directly to
the two (2) outputs without any processing or transcoding. Audio may be
extracted from the HDMI inputs if desired by pressing the HDMI button
on the front panel for the source that is currently selected. These HDMI
inputs are all v1.4 compatible and pass through all 3D formats. All HDMI
inputs can extract and decode all current HD audio formats up to and
including Dolby TrueHD and DTS-HD Master Audio
2
Zone 2 Outputs (Unbalanced RCA)
A pair of RCA jacks that provide a second stereo signal path completely
separate from the main output with its own independently selected inputs
3
TV Loop (Analog Inputs and Outputs)
A conventional TV loop consisting of two pairs of RCA jacks; one stereo
pair of inputs and one stereo pair of outputs. A stereo down-mix for the
selected source (or, in 2 Channel Bypass mode, the Left and Right
analog inputs directly) appear at the TV OUTPUTS, unless the selected
source is the TV INPUT itself in which case the TV OUTPUTS are
muted. The inputs can also be used as another pair of analog inputs, at
unity gain.
4
DVR Loop (Analog Inputs and Outputs)
A second record loop which functions same as the TV Loop above.
5
Unbalanced Analog Inputs
Four pairs of general purpose analog inputs labeled BLU-RAY,
SAT/CBL, GAME and MEDIA.
6
HDMI Outputs
HDMI Outputs (1) and (2). Always connect the primary display to HDMI
(1). HDMI video is switched to these outputs from the HDMI inputs
above. More detailed information on the use of both outputs is below in
section
USING DUAL HDMI OUTPUTS on pg - 22 -.
7 S/PDIF Digital COAX Inputs
The BLU-RAY, SAT/CBL, GAME, and MEDIA PLAYER front panel
selectable sources are supplied with a COAX RCA jack digital audio
input. These four inputs will accept any standard S/PDIF source PCM (2
channel), Dolby Digital and DTS formats. These input assignments can
be changed at any time.
8
USB 2.0 Type A Input
Used as a digital audio and control input from computers and similar
sources.
This source does not have any video assigned. The last used
video source will remain active when selecting this input. To select a
video source first select the active video source and then select the 7.1
or USB input. If no video is required then do not first select a video
source.
9
RS232 9-Pin Serial (Female)
Serial data port utilizing a DB9 female connector. For connection to
system control systems such as Crestron, Savant, AMX and others.
10
Power Cord Inlet
Use with a standard IEC removable power cord (included).
11
Ethernet 10BaseT (RJ45) Port
For interconnection to personal computers (and/or routers) to facilitate
SDP-45 software updates; and also for control functions through system
controllers (Crestron, AMX, etc.). This acts an HTTP server.
12
Toslink Optical Digital Inputs and Output
The DVR, and TV front panel selectable sources are also supplied with a
standard optical digital audio input. These three inputs will accept any
standard S/PDIF source PCM (2 channel), Dolby Digital and DTS
formats. These input assignments can be changed at any time.
The Toslink Digital output always sends a digital signal that is identical to
the MAIN Left and Right output. No down-mixing or bitstream pass
through is used.