JBL Synthesis SDP-45 4K - Manual (Page 39)

JBL SYNTHESIS SDP-45
Setup
- 39 -
SOURCE SETUP

The SOURCE SETUP Menu includes all those options that can be set on a per source basis. The sources can also all use the same settings on a global
basis The SOURCE SETUP menu is controlled by the currently active source in the main zone. For example, the Main Zone is selected to BLU-RAY. All
source setup parameters that are shown will relate to the BLU-RAY input only.
SOURCE INDIVIDUAL: The Factory Default and preferred operation is to use source INDIVIDUAL settings. This setting allows changes to be made
that only apply to the currently selected source. While the parameter is INDIVIDUAL then all source settings can be changed on a per source basis.
Changes made do not affect other sources and the settings are outlined below. All menu options contained in the source setup menu are controlled by the
GLOBAL/INDIVIDUAL parameter, as well as the default playback modes as shown below.
SOURCE GLOBAL: A small letter g will appear on the MAIN MENU to indicate that GLOBAL is turned on. SOURCE SETUP parameters for the currently
selected source become applicable to all other sources after changing from INDIVIDUAL to GLOBAL. Conversely, changing from GLOBAL to
INDIVIDUAL restores the original source parameters present at a time before INDIVIDUAL was previously changed to GLOBAL. It is very important to
check all sources for proper setup when changing from GLOBAL to INDIVIDUAL.
SOURCE SETUP DEFAULTS :
SPEAKER SIZE SPEAKER LEVEL CROSSOVER SUBWOOFER TRIGGERS DIGITAL OUT LIP SYNC FORMAT DETECT Surround Mode*
FRONT: SMALL
CENTER: SMALL
SIDE: SMALL
REAR: 2 SMALL LEFT: 0dB
RIGHT: 0dB
CENTER: 0dB
SIDE LEFT: 0dB
SIDE RIGHT: 0dB
BACK LEFT: 0dB
BACK RIGHT: 0dB
SUBWOOFER: 0dB FRONT: 80hz
CENTER: 80hz
SIDE: 80hz
BACK: 80hz ON
OFF in 2ch Bypass
Xtra Bass OFF 1: ON
2: ON
3: ON ZoneDAC
(downmix similar to
Headphone) 0ms AUTO 2 channel Input:
Dolby PLIIx Movie
Dolby 5.1 Input:
Dolby PLIIx Movie
DTS 5.1 Input:
7.1 Output
5.1 PCM Input:
Dolby PLIIx Movie
*The surround mode is not selectable, but uses a “last used” memory. If the SOURCE is set to GLOBAL then all sources will use the same surround mode.
The settings for each source for Analog Audio, Digital Audio or HDMI Audio input are controlled from the front panel and are not shown in the
setup menu. You do not need to open the setup menu to control these options, and no menu control exists.
NOTE