JBL Synthesis SDP-45 4K - Manual (Page 34)

JBL SYNTHESIS SDP-45
Setup
- 34 -
BRIGHTNESS:
Select from 25% / 50% / 75% / 100% front panel LCD display brightness.
The default is 50%
HEADPHONES:
[Not Available In All Regions] Sets the headphone output level Offset
from -12dB to +6 from the Main Zone volume level
PRESET VOLUME ON:
Sets the turn on volume of the Main Zone output from -60dB to +10dB.
The default setting is -40dB.
AUX:
The AUX L + R outputs can be used as an additional stereo pair or to
duplicate the Center and Subwoofer signals of the Main Zone output.
The default is Stereo L+R. The two options are:
Stereo L+R: This routes a stereo down-mix signal on the two AUX
output jacks, the same stereo down-mix that appears on the
headphone jack.
Center & Sub: This option routes the Center channel onto the L-
AUX connector and the SUB channel onto the R-AUX connector thus
facilitating the use of two sub-woofers and/or two Center channel
speakers.
AUTO SAVE:
The changes made to the setup and operation of the SDP-45 can be
automatically saved as you make the changes, and no additional step is
needed. This is the default setting: ON. When set to on the system will
automatically save the settings as you exit the setup menu. You can also
set the unit to NOT save automatically and in this case you will need to
save manually. WE DO NOT RECOMMEND CHANGING THIS
PARAMETER.
DISP TIMEOUT
The time it takes for the Setup Menu to time out and return to the Status
Menu. This parameter also controls the time it takes for the LCD display
and/or the LED lights to time out and turn off. The default setting is for
the LCD display timeout of 10 minutes, with no time out on the LED
lights.
When the option is set to DISPLAY+LED all the lights on the
front panel and LCD display will turn off. The unit will look dark and OFF
but will still be operational. Pressing any button or changing the volume
will turn on the display and LED lights for the selected time.
The options are:
Display Timeout 2 Minutes
Display Timeout 10 Minutes
Display Timeout 30 Minutes
Display Timeout 120 Minutes
Display+LED Timeout 2 Minutes
Display+LED Timeout 10 Minutes
Display+LED Timeout 30 Minutes
Display+LED Timeout 120 Minutes
SPEAKER DIST UNIT:
Select between Meter (M) and Feet (ft). The default is Feet.
TRIG DELAY:
The delay before the DC triggers located on the rear panel turn on after
becoming active as set in the Source Setup menu for each source. The
default is 0 seconds. The options are 0, 5, 10, 15, 20, 25, 30 seconds.
NOTE