Delay, Mode, Pan / blend balance – Logitek Electronic Systems Artisan User Manual
Page 28: Trim, Logitek
Logitek
5
Operation
S5, S6, S7, S8
S5
to S8 are additional Sub-master mix busses. To assign or de-assign a fader to Sub-master 5-8,
move the SELECT stick to highlight the appropriate mix bus, and then rotate the stick to toggle the
assignment on and off.
Delay
Use the SELECT stick to toggle to the Delay menu selection and rotate the encoder to adjust the
delay time. Delay of up to 0.5 seconds is available, in 10ms increments.
Mode
Move the SELECT stick to highlight the input mode. Then turn the stick to move between the
options of; STEREO, MONO, BLEND, PHASE, LL, RR, Lx and xR. The mode is changed as you
make the selection. Press down on the stick to accept and exit the menu. This function may not be
enabled on certain inputs, depending on your Audio Engine configuration.
Pan / Blend Balance
After highlighting the PAN function, turn the SELECT stick to move the balance left or right by
turning the stick counter-clockwise or clockwise. In STEREO or MONO mode, the source is panned
as you turn the stick. In BLEND mode the emphasis between the two mono sources is adjusted.
Press down on the stick to accept and exit the menu. This function may not be enabled on certain
inputs, depending on your Audio Engine configuration
Trim
After highlighting the TRIM function, turn the SELECT stick to move the TRIM between -60 dB and
+20 dB
by turning the stick counter-clockwise or clockwise. The trim level is adjusted as you turn
the stick. Press down on the stick to accept and exit the menu. This function may not be enabled on
certain inputs, depending on your Audio Engine configuration.
EQ
To edit the EQ settings for an input, move the SELECT stick to select the EQ function. Turn the stick
to toggle between EQ in and out. Press down on the stick to bring up the EQ settings menu. Move
the stick to select a parameter, and then turn the stick to adjust. The parameters are:
Hi F
High Frequency
4,000 to 20,000 Hz
Hi G
High
Gain
-18
to
+18
dB
HM F
High-mid
Frequency
1,000
to
20,000
Hz
HM G
High-mid
Gain
-18
to
+18
dB
HM BW
High-mid
Bandwidth 10
to
4,000
Hz
LM F
Low-mid
Frequency
30
to
8,000
Hz
LM G
Low-mid
Gain
-18
to
+18
dB
LM BW
Low-mid
Bandwidth 10
to
4,000
Hz
Logitek Artisan Reference Manual
26