Logitek Electronic Systems Artisan - Manual (Page 29)

Logitek
5
Operation
Lo F Low frequency 30 to 1,000 Hz
Lo G Low Gain -18 to +18 dB
Mode In or Out
Press down on the stick again to save and exit the menu.
” TIP: EQ adjustments can be adjusted more easily on the MTK-EFFECTS module, if fitted.
When you press the CNG button on a Fader module, it will be selected to the
Effects module.
DYN
To edit the dynamics (limiter and compressor) settings for an input, use the SELECT stick to select
the DYN function. Turn the stick to toggle between dynamics in and out. Press down on the stick to
bring up the dynamics settings menu. Move the stick to select a parameter, and then turn the stick
to adjust. The parameters are:
L THR Limiter Threshold -20 to +20 dB
L RAT Limiter Ratio 1 to 40
L REL Limiter Release Time 10 to 1000 mSec
C GAIN Compressor Gain 0 to 21 dB
C THR Compressor Threshold -40 to 0 dB
C RAT Compressor Ratio 1 to 40
C ATK Comp. Attack Time 5 to 68 mSec
C REL Comp. Release Time 100 to 6000 mSec
Mode In or Out
Press down on the stick to save and exit the menu.
”
TIP: Dynamics adjustments can be adjusted more easily on the MTK-EFFECTS module, if
fitted. When you press the CNG button on a Fader module, it will be selected to
the Effects module.
IN
Use the IN function to select other sources that have been permitted for that fader. If only one
source has been allowed for a fader, then no list will be available.
When not in CNG mode, simply turn the SELECT stick to scroll through the list of inputs. You can
also reach the IN function by moving the stick to highlight IN, then pressing TAKE.
Once you have found the source that you wish to route to that fader, press the SELECT stick to
accept the change. Press the CNG button to cancel the change.
Logitek Artisan Reference Manual 27