Logitek Electronic Systems Artisan - Manual (Page 40)

Logitek
5
Operation
vSnapshot
vSnapshot captures the entire profile of the surface at the time the CAPTURE button is pressed,
prompting you to save a profile. By default, MLX-WSOFT diamond buttons 11 & 12 are used for
CAPTURE & RECALL respectively.
” TIP: You may change the buttons assigned to capture and recall using Triggers.
When you execute the CAPTURE function, all bus assignments, ON/OFF status, EQ and DYN
parameters, etc. along with current fader levels are stored in a profile that you determine. When
executed, you will be presented with a screen as shown below.
Figure 20 - vSnapshot
When a profile is recalled, the stored fader levels may be different to the current fader levels on the
surface at the time of recall. The recalled level is displayed as a numeral above and to the right
of the S5 S6 S7 S8 line. The level of the physical fader on the surface is displayed to the left of the
recalled value. The physical fader is inactive until it passes through the value set by the recall (when
the two numbers match). Once this occurs, the two numbers representing the recalled and physical
fader values disappear and the physical fader now resumes normal control of the fader level.
¬ For more information on configuring vSnapshot, see the vTools Reference Manual.
Logitek Artisan Reference Manual 38