Logitek Electronic Systems Artisan - Manual (Page 56)

Logitek
Appendix E
Additional Protocol Commands
Appendix E Additional Protocol Commands
This section documents Logitek Protocol commands specific to the Artisan surface. These
commands add additional support for functions such as meter bridge feature locations, timer
controls and advanced feature sets.
The standard set of Logitek Protocol commands (such as channel on; channel off; input route;
fader level; etc, is documented in the Logitek Protocol Reference.)
Artisan Busses
These Bus settings supplement/replace the standard busses available in the Logitek system. Please
note the Artisan uses assignment Busses that differ from Logitek radio consoles.
Bus Assignments
BUS0 On/Off Switch
BUS1 Master 1
BUS2 PFL/CUE
BUS3 Master 2
BUS4 Sub-master 1
BUS5 Sub-master 2
BUS6 Sub-master 3
BUS9 Sub-master 4
BUS10 Sub-master 5
BUS11 Sub-master 6
BUS12 Sub-master 7
BUS13 Sub-master 8
”
TIP: Aux Sends are not controlled by Bus Assignments but can be externally controlled
using the Set Effects command documented later in this appendix.
Fader Functions
BUS17 Channel On button lamp address
The above Bus is used to address Artisan Color or Flash commands to the fader ON button. The
lamp state is not addressed by this command; instead it is tied to the channel’s BUS0 state.
BUS37 Select mode for “IN” button – OFF = last input / ON = default input
BUS38 Master 1 bus lock (ON = locked)
BUS39 Master 1 bus lock (ON = locked)
BUS40 Sub-master 1 bus lock (ON = locked)
BUS41 Sub-master 2 bus lock (ON = locked)
BUS42 Sub-master 3 bus lock (ON = locked)
BUS43 Sub-master 4 bus lock (ON = locked)
BUS44 Sub-master 5 bus lock (ON = locked)
BUS45 Sub-master 6 bus lock (ON = locked)
BUS46 Sub-master 7 bus lock (ON = locked)
BUS47 Sub-master 8 bus lock (ON = locked)
Logitek Artisan Reference Manual 54