Epson Stylus TX100 - Manual (Page 31)

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 31
Confidential
• Operation
• Anywhere The Scanner Carriage Unit. does not
operate.
Lower Scanner
Housing
1. Check if the grease is enough on the Guide Rail of the
Lower Scanner Housing. (TBD)
1. After wiping the grease on the Guide Rail of
the Lower Scanner Housing with a dry, soft
cloth, coat it with grease. (Refer to
Chapter 6
"MAINTENANCE" (p.116) .) (TBD)
2. Check if the Scanner Carriage Unit is correctly
assembled.
2. Reassemble the Scanner Carriage Unit
correctly.
• Power on
• Anywhere When turning on the power, the CR
Motor does not operate at all.
CR Motor
1. Check if the CR Motor Cable is connected to J7 on the
Main Board.
1. Connect the CR Motor Cable to J7 on the Main
Board.
2. Check if the CR Motor Cable is damaged. 2. Replace the CR Motor with a new one.
3. Check if the CR Motor operates. 3. Replace the CR Motor with a new one.
Table 3-2. Check point for Fatal error according to each phenomenon
Occurrence timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
J7
CR Motor Cable