Epson Stylus TX100 User Manual
Page 76
Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300
Revision A
DISASSEMBLY/ASSEMBLY
Disassembling the Printer Mechanism
76
Confidential
Route the CR Motor cable through the four hooks and the two
grooves of the Lower Housing with some slack to prevent
breaking the soldered portions. (See
)
Be sure to install the CR Motor with the groove facing upward.
Figure 4-47. Installing the CR Motor
CR Motor
Groove
Soldered Portions
When installing the Timing Belt to the Pinion Gear of the CR Motor
follow the procedure below taking care not to twist the Timing Belt.
1. Align the hooks of the Driven Pulley with the hole of the Main
Frame, and install the Driven Pulley to the Main Frame.
2. Attach the Timing Belt to the Driven Pulley with toothed side
facing inward. (See
)
3. Install the Compression Spring between the protrusion of the
Driven Pulley and that of the Main Frame. (See
)
4. Slide the Driven Pulley to the CR Motor (in the direction of the
arrow) taking care not to let the Timing Belt come off, and install
the Timing Belt to the Pinion Gear of the CR Motor. (See
)
Figure 4-48. Installing the Driven Pulley
A D J U S T M E N T
R E Q U I R E D
Whenever the CR Motor is removed/replaced, the required
adjustments must be carried out.
•
Chapter 5 “ ADJUSTMENT” (p.100)
After replacing the Driven Pulley, be sure to perform the
required lubrication.
•
Chapter 6 “ MAINTENANCE” (p.108)
Main Frame
Hole
Driven Pulley
Hook