Epson Stylus TX100 - Manual (Page 91)

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 91
Confidential
4.5.13 LD Roller/ ASF Unit
† Parts/Components need to be removed in advance:
Scanner Stand/Cover Wire ( p 60 ), Scanner Unit ( p 62 ), Middle Housing ( p 63 )
Panel Unit ( p 64 ), Hopper ( p 72 ), Main Board ( p 65 )
CR Motor/ Driven Pulley ( p 75 ), Ink System( p 77 ), PF Encoder/ PF Scale( p 73 )
Main Frame ( p 84 )
† Removal procedure
1. Rotate the LD Roller Assy until the flat part of the LD Roller Assy faces
upward.
2. Hold the Paper Back Lever outward using tweezers as shown below.
3. Remove the LD Roller Assy from the ASF Unit Shaft Hole while opening the
Lever Pick Clutch as shown below.
Figure 4-90. Removing the LD Roller Assy
4. Remove the three screws that secure the ASF Unit.
5. Release the hook and remove the ASF Unit from the Lower Housing.
Figure 4-91. Removing the ASF Unit
6. Remove the Extension Spring at the bottom of the Retard Roller Assy.
7. Remove the Retard Roller Assy from the ASF Housing.
Figure 4-92. Removing the Retard Roller Assy
C A U T I O N
Be careful not to touch the LD Roller Assy and the roller part of the
Retard Roller Assy with bare hands to avoid degrading the print
quality.
ASF Unit Flat part
LD Roller
Shaft Hole
LD Roller Assy
Tweezers
Paper Back Lever
Lever Pick Clutch
ASF Unit
Positioning Hole and Dowel
Hook
SCREW M3x10 P-TITE (5±0.5kgfcm)
Retard Roller Assy
Extension Spring
ASF Housing