Epson Stylus TX100 - Manual (Page 43)

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 43
Confidential
Table 3-7. Check point for Ink out error / No ink cartridge error read error / write error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Power on
• Inside HP After the printer detects that the carriage
is at the home position, an error is
displayed.
Ink Cartridge
1. Check if Ink Cartridge is properly installed. 1. Install the Ink Cartridge properly.
2. Check if the Memory Chip is disconnected or chipped. 2. Replace the Ink Cartridge with a new one.
CR Contact Module
1. Check if the Head FFC is connected correctly to the
connector on the CR Contact Module.
1. Connect the Head FFC to the connector on the
CR Contact Module.
2. Check if the CSIC Board is damaged. 2. Replace the CR Contact Module with a new
one.
Contact Assy
3. Check if the Contact Assy is damaged. 1. Replace the Contact Assy with a new one.
Memory Chip
Connector
CR Contact Module is behind
Holder Contact Assy.
Head FFC
Contact Assy