Epson Stylus TX100 - Manual (Page 51)

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 51
Confidential
• Print start position
slip
The printing operation is correctly
performed. But, the top margin is
insufficient than usual one.
LD Roller
1. Check if paper dust is adhered to the surface of the LD
Roller.
1. Set a cleaning sheet in the ASF up side down.
Then holding the top edge, try to load the paper
from the Printer driver. The micro pearl on the
LD Roller surface is removed. To remove
severe smear, staple a cloth moistened with
alcohol to a post card and clean the roller in the
same manner. As for the cleaning sheet, refer to
“ Check point for Paper out error according to
each phenomenon ” (p.40)
.
* If the problem is not solved, replace the ASF
Unit with a new one.
• Ink stain of paper
Ink stain occurs at the back, top end or
bottom end of the print paper.
Lower Housing
1. Check if the Lower Housing is free from ink stain. 1. Clean the Lower Housing with a soft cloth.
2. Check if heaps of ink are formed on Porous Pad Front
Paper Guide.
2. Replace the Lower Housing with a new one.
EJ Roller Assy 1. Check if the EJ Frame Assy is free from ink stain. 1. Clean the EJ Frame Assy with a soft cloth.
PF Roller Assy 1. Check if the PF Roller Assy is free from ink stain. 1. Clean the PF Roller Assy with a soft cloth.
Table 3-12. Check point for the defective printing quality
Print Quality State Detailed phenomenon
Defective
unit/part name
Check point Remedy
LD Roller
Lower Housing (Front Paper Guide)
Porous Pad Front Paper Guide