Extron Electronics MLC 104 Plus Series - Manual (Page 178)

Firmware Updates, cont’d
MLC 104 Plus Series • Firmware Updates B-8
PRELIMINAR
Y
6. Set the maximum number of firmware uploads that can take place at the
same time. The firmware files are uploaded to batches of this many units at a
time until all units listed in the Select Device list have received new files. The
default is 5 uploads at a time, and the upper limit is the total number of units
shown in the Select Device list.
7. Select the MLCs for the firmware update.
•
Ctrl-click on the name(s) of the unit(s) to select (or deselect) more than
one unit in the list.
• Click on one unit’s name and Shift-click on the name of another unit to
select those two MLCs and the MLCs listed between them.
8. Click Browse, then locate and select the firmware file you downloaded.
9. Click Begin, then confirm that you want to start uploading the firmware. The
software displays the progress and status of the firmware upload for each
unit, then performs a firmware validation before finishing. If uploading fails,
you can view the error log by clicking on View Log. If uploading is successful,
the Status column indicates success for each unit.
10. Click Close.
11. Close the IP Link File Manager software.
12. Restore the MLC’s configuration from a previously saved file.