Epson AcuLaser C9300 - Manual (Page 14)

Chapter 2
How To
Overview
This section describes the general procedure on how to set up the network interface for use on a
network.
1. Check the network interface operation.
Check the functions and operations of the network interface, such as status lights and RJ-45
connector. See “Network Interface Operation” on page 11 for details.
2. Select a printing method.
Select a printing method appropriate for your network environment and operating system. If you
are not sure, see “Printing from Windows” on page 15 or “Printing from Macintosh” on
page 15 for details.
3. Install the necessary components on your computer.
Make sure the necessary components (such as TCP/IP) are installed on the computer, and
network settings (such as IP address, subnet mask, etc.) of the computer is set. See “About
Installing Components on Your Computer” on page 17 for details.
4. Connect the network interface to the network.
Connect the network interface to the network. See “Connecting the Network Interface to the
Network” on page 23 for details.
5. Configure the network interface and install the printer driver.
See “Configuring the Network Interface (For Windows Users)” on page 24 or “Configuring the
Network Interface (For Macintosh Users)” on page 25 for details.
6. If necessary, configure the network settings of the network interface using EpsonNet Config.
Configure the network interface for TCP/IP, AppleTalk, etc. using EpsonNet Config. For
Windows users, see “About EpsonNet Config” on page 48. For Macintosh users, see “About
EpsonNet Config” on page 50.
Epson Network Guide
How To 14