Epson AcuLaser C9300 - Manual (Page 80)

Note:
❏ To use Auto, a DHCP server must be correctly configured on the network. See the online help of
your operating system for detailed instructions.
❏ Choose PING only when setting the IP address using the arp/ping command.
6. Press the Up or Down button until IP = xxx.xxx.xxx.xxx appears. Press the Right button.
7. Press the Up or Down button until the desired value appears. Then press the Right button to set
the value.
Note:
Repeat steps 7 and 8 to set the IP address, subnet mask, and default gateway.
8. Press the Start button to exit the control panel menus.
9. Turn off your printer and then turn it back on. Be sure to wait until the initialization is complete.
Print a network status sheet to confirm the new IP address.
Note:
❏ You must first set the IP address before using EpsonNet Config with Web Browser.
❏ See the User’s Guide for more information about settings on the printer’s control panel.
Network Menu
These items are used to make network settings on the printer’s control panel.
Item Settings
Network I/F On, Off
Get IPAddress Panel, Auto, PING
IP 0.0.0.1 to 255.255.255.254
SM 0.0.0.0 to 255.255.255.255
GW 0.0.0.0 to 255.255.255.255
AppleTalk On, Off
MS Network On, Off
Epson Network Guide
Tips for Administrator 80