RIGOL DSG3000 Series - Manual (Page 109)

Chapter 3 Remote Control RIGOL
DSG3000 User’s Guide 3-3
Control Via USB
1. Connect the device
Connect the RF signal generator (USB Device) and PC (USB Host) using USB
cable.
2. Install USB drive
This RF signal generator is a USBTMC device and the New Hardware Wizard
will be displayed after the RF signal generator is correctly connected to the PC
(the signal generator will be automatically configured to USB interface) and both
of them are started. Please install the “USB Test and Measurement Device” drive
program according to the instructions.
3. Search for device resource
Start Ultra Sigma and the software will search for the RF signal generator
resource currently connected to the PC automatically. You can also click
to search for the resource manually.
4. View device resource
The instrument model and USB interface information will be displayed under the
“RIGOL Online Resource” directory, as shown in the figure below.
Figure 3-1 View USB Device Resource