Rose Electronics MultiVideo - Manual (Page 11)

MULTIVIDEO INSTALLATION AND OPERATIONS MANUAL 9
Appendix C. Rack mount
Rack Mount Instructions
The optional rack mount kit includes the following items:
• Two black anodized mounting brackets.
• Four 6 x 32 x 3/8” flat head mounting screws.
• Mounting instructions insert.
To rack mount your MultiVideo, attach the two rack mounting brackets to
your unit with the short flange against the unit using the four screws
provided. Secure the mounting brackets to the rack using the appropriate
size bolts, nuts and lock washers. Using hardware other than that provided
could cause damage to the electronics and/or result in loss of mounting
integrity. Do not over tighten the screws used to mount the unit to the
mounting brackets.
The following general guidelines should be observed when installing your
unit into a rack.
a). The MultiVideo is designed to work in an ambient temperature of
0 ο C to 45 ο C (32 ο F – 113 ο F).
b). Do not block power supply vents or otherwise restrict airflow when
rack-mounting this unit.
c). Mechanical loading of the rack should be considered to prevent
instability and possible tipping over.
d). Tighten all connectors securely and provide adequate strain relief
for all cables.
e). Provide a grounded power source to all units. Pay special
attention to overall branch circuit load ratings before connecting
equipment to this source. Overloaded circuits are potential fire
hazards and can cause equipment failures or poor performance.