Rose Electronics MultiVideo - Manual (Page 22)

INSTALLATION
8
ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL
Organizing the system
It is recommended that before any UltraView Pro configuration or cable
connections be made, plan how the system will be laid out, the placement
of the CPUs and the placement of the UltraView Pro. Take into
consideration the cable lengths needed to connect to the KVM station and
each CPU. Identify which CPU will be connected to computer 1’s DB25
connector, computer 2, and so on.
The default computer names that the UltraView Pro uses to identify the
computer are computer 1, computer 2, and so on. These names can be
changed using the on-screen “Configure computer” menu.
Installation – single unit
This section explains how to connect and initially configure the UltraView
Pro. If you are cascading two or more UltraView Pro units together, please
refer to the Cascade installation section.
NOTE: Some installation procedures and menu selections may not be
available on the PC model.
Step 1. Connecting the keyboard, video monitor, and
mouse
Connect the KVM stations keyboard, video monitor and mouse cables to
the corresponding connectors of the appropriate KVM cable as shown in
Figure 8. The KVM cable should have the correct connector types for the
equipment used. Connect the DB25M connector into the connector labeled
“Monitor/Keyboard/Mouse” on the UltraView Pro rear panel.
Step 2. Apply power to UltraView Pro
For the “M” chassis, connect the power transformer to a 110/220-volt
source and to the DIN 5F power adapter connector on the rear panel. Press
the ON/OFF button in the front panel once to turn on the unit.
For the “B” and “C” chassis, connect a power cord to 110/220-volt source
and to the IEC320 connector on the rear panel. Press the rocker switch to
the ON position.