Rose Electronics MultiVideo - Manual (Page 40)

OPERATION
26
ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL
Selecting a computer
To connect to a computer, you can select it from the UltraView Pro’s front
panel, select it by keyboard commands, select it through the RS232 serial
port, or you can select the computer from a computer select window as
shown in Figure 15.
Selecting a computer from the front panel
Using the + and – buttons on the front panel will advance (+) or switch to
the previous (-) computer port.
Selecting a computer using keyboard commands
Press and release the left control <Ctrl> key, then enter the computer port
number. Pressing and releasing the left control <Ctrl> key then the “+” or “–
“ key will advance forward or backwards one sequential port.
Selecting a computer through the RS232 port
Selecting a computer can be done through the RS232 port if needed.
Contact Rose Electronics Technical support for details.
Selecting a computer using the Computer select window
Press and release the left control <Ctrl> key, then press Esc. The
computer select window will display. Use the up/down arrow keys and
select the computer to switch to and press enter. You will be immediately
connected to that computer. Use the page up/down keys if there are more
than 16 computers in your system.
Figure 15. Computer select window
Computer select window
1
→
2 Computer 2
3 Computer 3
4 Computer 4
5 Computer 5
6 Computer 6
7 C t 7