Rose Electronics MultiVideo - Manual (Page 43)

ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL
29
Keyboard command usage
When using keyboard commands to enter information to the UltraView Pro,
please observe the following guidelines to avoid entering incorrect values or
no values.
1. All commands start with a press and release of the left control key.
2. Commands following the press and release of the left control key must
be entered within 2 seconds or control reverts to the connected
computer and the command will be sent to that computer and not the
UltraView Pro.
3. Use only the numeric keys above the keyboard and not the numeric
keypad.
4. Letter commands such as <Ctrl> L are not case sensitive and are only
shown in uppercase for clarity. Do not use the shift key to enter letter
commands.
5. To connect to the next or previous computer, the keyboard command
is <Ctrl> + or <Ctrl> -. The plus and minus keys on the keypad will
connect to the next or previous computer. The + and – keys on the
keyboard, next to the backspace key vary from country to country as to
their usage. These keys can still be used to connect to the next or
previous computer.
Reset to factory defaults
To reset the UltraView Pro to the original factory default settings, first,
power down the unit, press and hold the – (minus) switch in and turn the
power on to the unit. Keep the – (minus) switch held in until the unit
switches to the last port on the unit (port 4, 8, or 16). If you release the –
(minus) switch before the last port is switched to, the defaults will not be
restored. The configuration and access passwords are not reset using this
procedure.
Rackmounting
The UltraView Pro can be rack mounted using a Rose Electronics
Rackmount kit. See Appendix D and E for instructions.