Rose Electronics MultiVideo - Manual (Page 56)

42
ULTRAVIEW PRO INSTALLATION AND OPERATIONS MANUAL
Appendix D. Rack mount instructions
The UltraView Pro can be mounted in a rack using the Rackmount kits from
Rose Electronics.
The optional rack mount kit includes the following items:
 Two black anodized mounting brackets.
 Four 6-32 x 3/8” flat head mounting screws.
To rack mount your UltraView Pro, attach the two rack mounting brackets to
your unit with the short flange against the unit using the four screws
provided. Secure the mounting brackets to the rack using the appropriate
size bolts, nuts and lock washers. Using hardware other than that provided
could cause damage to the electronics and/or result in loss of mounting
integrity. Do not over tighten the screws used to mount the unit to the
mounting brackets.
The following general guidelines should be observed when installing your
unit into a rack.
1. The UltraView Pro is designed to work in an ambient temperature of 0
ο
C to 45
ο
C (32
ο
F – 113
ο
F).
2. Units should be placed (1) rack space apart from each other and from
other equipment.
3. Rack vent panels (1 space) should be installed between units to
provide adequate air flow to the unit.
4. Keep front and rear doors closed on racks equipped with forced air
blowers or fans.
5. Do not block power supply vents or otherwise restrict airflow when
rack-mounting this unit.
6. Mechanical loading of the rack should be considered to prevent
instability and possible tipping over.
7. Tighten all connectors securely and provide adequate strain relief for
all cables.
8. Provide a grounded power source to all units. Pay special attention to
overall branch circuit load ratings before connecting equipment to this
source. Overloaded circuits are potential fire hazards and can cause
equipment failures or poor performance.
Appendix E. Rack mount illustration