Rosen Aviation 1702 Series : 17.5 inch WideScreen High definition - Manual (Page 26)

Rosen Aviation 17.5” HD Widescreen Display
Document Number: 102990 Revision: C
Date: 03/17/14
Template: 4.2.3-6-FM; Revision A; 16 May, 2005 Page 26 of 34
8.7.1. Momentary Switch Mode
Momentary enables you to specify those sources that will be On or Off and cycle
between only the enabled video sources. If the select switch pin #2 (SELECT_SW_IN) is
grounded for more than 150ms, the display will toggle to the next enabled source. This
mode also contains an option to specify an Auto Detect source.
If the source specified in the Auto-Detect option is connected, the display will ignore all
source commands. When that source is removed, the monitor will return to normal
momentary operation.
Note: When auto-detecting a source, sources 1 & 2 are no longer selectable during
normal momentary operation.
Note: Be sure to set Auto Detect to None Selected before switching from Momentary to
Constant; otherwise, the image may flash off and on.
Highlight TechnicianSource ModeMomentary and press ENTER.
Use the ▼ to select Auto Detect and press ENTER.
Select which video input will be in an auto-detected state and press ENTER.
Use the arrow buttons to turn the other video inputs On/Off and press ENTER.
Select Back to return to the Technician Menu.
Press EXIT to exit the OSD.
Figure 30 Momentary Switch Mode settings
Set Auto Detect to None
Selected if Source
Select will be Constant
mode