Amprobe DMIII-Multitest Power-Quality-Recorder - Manual (Page 68)

AMPROBE
DMIII MULTITEST
EN-66
d) After checking, and if needed modifying, the connection of the instrument to the
equipment re-set the 3 wires mode and the connections shown in the picure above
(yellow and red wires together).
5. Energize the electrical equipment under test.
6. The values of the available electrical parameters will be displayed of the instrument.
For further details see the paragraph relevant to the position of the switch.
7. You can press HOLD to interrupt the updating in real time of the displayed values.
8. If you want to record:
a) Check and modify the values of the basic parameters (see paragraphs 7.1 and 7.2).
b) Check and eventually modify the recording parameters by pressing MENU (see the
paragraph corresponding to the position of the rotary switch selected).
c) To start the recording press START (see paragraph 10.1).