Amprobe AT-5000 Underground-Wire-Tracer - Manual (Page 13)

11
Push Select to activate the desired configuration. The transmitter displays the active configuration and returns to the operational
display screen.
frequency Menu
The T-5000 Transmitter frequency menu allows the operator to configure the desired active frequency (ies). Different menu
screens appear depending upon the connection mode – direct (conductive), inductive coupling with clamps, or inductive
antenna. The operator can then select the desired available frequencies.
Sheath fault locating (SFL) frequency selection is discussed separately.
The desired menu is selected using the three-button navigational keypad.
Push Menu.
Push the up/down arrows to select the desired menu option.
Push Select to open the desired menu screen.
Push Menu to return to the operational display screen.
frequency Menu - direct (Conductive) Connection Mode
Direct (conductive) connection mode allows the operator to configure up to three active frequencies. The operator is limited to
selecting one frequency in each frequency menu – low, mid, and high.
The desired frequency settings menu is configured using the three-button navigational keypad.
Push the • up/down arrows to select the desired option.
Push • Select to open the desired frequency settings menu.
Push • Menu to return to the previous screen.
The desired frequency is configured using the three-button navigational keypad.