PLANET IPX-1500 - Manual (Page 33)

not returning traffic.
Please click Setting button to enter into Port mapping configuration:
Add：Clicking Add button to step up the machine the packet want to be transferred.
Service type: Please make sure the protocol type service use.
TCP(Transmission Control Protocol)，UDP(User Datagram Protocol) or BOTH
Source port: Please fill the port service using
Target port: Please fill the port service will be transferred to
Target IP: Please fill the IP Address of the responsible machine
Edit：Please select the service port transparent，clicking Edit to modify the port and IP Address.
Remember to save after changing.
Delete：Please select the service transparent，clicking delete to remove the service you don’t want to
transparent.
Return：Go back to the last page
Virtual DMZ
In certain situations, you may want to set up a virtual DMZ on one of the computers on your network.
When you establish a virtual DMZ, you open all inbound ports and direct the base station to forward
certain inbound data packets (those that are not in response to a transmission initiated by a local
networked computer and not handled through application-triggered or persistent port forwarding) to a
particular computer on your local network. This computer becomes the DMZ host.
A virtual DMZ, however, should be used only in very specific situations. The computer that hosts the
virtual DMZ is fully exposed to the Internet, and is thus susceptible to malicious attacks and
unauthorized access. If a hacker were to upload a virus to the virtual DMZ, the virus could spread to all
the computers on your network.
Please click Setting button to enter into Virtual DMZ configuration:
33