Datalogic QuickScan Lite QW2100 - Manual (Page 57)

ACK NAK Options
Product Reference Guide 47
ENTER/EXIT PROGRAMMING MODE
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
ACK Character on page 251
for more detailed programming instructions.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See
NAK Character on page 252
for more detailed programming instructions.
NOTE
Setting to previously defined characters such as XON,
XOFF, or host commands conflicts with normal opera-
tion of these characters. 8-bit data is not recognized
when the option
Data Bits has been set as 7 Data Bits.
$CR2AC
Select ACK Character Setting
DEFAULT 0x06 ‘ACK’ Character
NOTE
Setting to previously defined characters such as XON,
XOFF, or host commands conflicts with normal opera-
tion of these characters. 8-bit data is not recognized
when the option
Data Bits has been set as 7 Data Bits.
$CR2NA
Select NAK Character Setting
DEFAULT 0x15 ‘NAK’ Character