Datalogic QuickScan Lite QW2100 - Manual (Page 58)

RS-232/USB-Com Interfaces
48 QuickScan TM Lite QW2100
ENTER/EXIT PROGRAMMING MODE
ACK NAK Timeout Value
This option specifies the amount of time the reader waits for an ACK character from the host
following label transmission. The selectable timeout range is 200 milliseconds to 15,000ms (15
seconds) in 200ms increments. A selection of 0 disables the timeout. See
ACK NAK Timeout
Value on page 253
for more detailed programming instructions.
$CR2AT
Select ACK NAK Timeout Value Setting
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
~
CANCEL
DEFAULT 01 ACK NAK Timeout value is 200ms