Mounting, Mounting display with a vesa mount, Mounting a peripheral device – Planar Systems URW105 105" 5K 21:9 Ultra-Wide Commercial Monitor User Manual
Page 19: 1 mounting display with a vesa mount, 2 mounting a peripheral device
19
Planar UltraRes W Series User Manual
020-1420-00A
Page | 19
9. Mounting
9.1 Mounting Display with a VESA Mount
If you purchased a VESA mount, you should have a received a separate box with mounting
supplies and an Installation manual. Follow these instructions carefully.
Keep in mind the following general installation guideline:
• Screw length is crucial and will vary depending on the type of mount you use. Total screw
length will include the penetration length plus the length required by the type of VESA
mount in use.
Caution:
Screws not sized to the depth specified can result in inadequate mounting strength or
damage to the internal components in the display. To prevent injury, this device must be
securely attached to the wall in accordance with the installation instructions supplied with the
mount. The mount must be secured to the Planar UltraRes W Series display using the four M8-
1.25 VESA mounting locations, and 10mm -15mm thread engagement is required for secure
mounting. Select the correct screw/spacer combination for the mount.
• Prior to installation, make sure you know where all of the mounting points are located.
• Follow all safety precautions outlined in the VESA Installation manual.
• Verify the parts received with the list shown in the VESA Installation manual.
9.2 Mounting a Peripheral Device
A 100 mm x 100 mm VESA mounting interface is located on the rear of the display to
accommodate a third-party media player or computer. If needed, local power is available
through the AC OUT connector.